Services
Services
The measurement and calibration disciplines available through Milwaukee CMM Calibration and Repair.
What Is Offered
Calibration and repair, programming support, and the gage crib that travels with the CMM on the same interval — all quoted against a checked scope of accreditation.
Services Offered
Each discipline below has its own page setting out method, scope and what a request should contain.
- 01
CMM Calibration
Performance verification against ISO 10360-2 or ASME B89.4.1, with as-found data, geometric adjustment and certificate issue.
View → - 02
CMM Programming
Offline and online part programs built to measure what the drawing requires, not just to run without error.
View → - 03
Gage Calibration
The gage crib that travels with the CMM on one interval, with accredited and non-accredited items clearly separated.
View →
How Work Is Performed
Work is performed under ISO/IEC 17025:2017. Each request is used to fix the methods, ranges and measurement points before work proceeds. Results are reported on a certificate or report stating the method used, the measurement conditions and the uncertainty.
Coverage across Milwaukee, WI and the wider Wisconsin and the Greater Midwest area is listed on the service areas page. The standards, traceability and management arrangements behind the work are set out on the quality system page.
Have a specific item to quote?
Send the item, measurement points, tolerances and required turnaround, and a written quotation is prepared and returned.